Table of Contents
Advertisement
ENGLISH
Bevel stop adjustment (Fig. 16a-16c)
WARNING: To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
90° (0°) Bevel adjustment (Fig. 16a-16b)
•
Unplug the saw.
•
Set the miter table at 0°.
•
Pull out the lock button and loosen bevel lock knob ,
tilt the cutting arm completely to the right. Tighten the
bevel lock knob .
2
•
Pull down the cutting head until the blade just enters
the table insert.
•
Place a framing square on the miter table and up
against the saw blade .
Fig. 16a
1
•
If the blade is not 90° (0°) square with the miter table,
loosen the bevel lock knob , tilt the cutting head
completely to the left, loosen two bolts on back of
saw with a 5 mm hex key (not supplied).
•
Tilt the cutting arm back to the right at 90° (0°) bevel
and recheck for alignment.
•
Repeat above steps if further adjustment is needed.
•
Tighten bevel lock knob and two bolts when
alignment is achieved.
Fig. 16b
2
90° (0°) Bevel pointer adjustment (Fig. 16c)
•
When the blade is exactly 90° (0°) to the table, loosen
the bevel indicator screw using the wrench (supplied).
•
Adjust bevel indicator to the "0" mark on the bevel
scale and retighten the screw.
9
14
1
3
4
5
5
3
4
2
6
2
6
6
1
6
7
8
Fig. 16c
2
45° Bevel adjustment
•
If the 90° (0°) bevel have been set correctly, you do not
need to adjust the 45° bevel.
Miter scale (Fig. 17)
The miter scale can be easily read, showing miter angles
from 0° to 52° to the left, and 0° to 60° to the right. The miter
saw table has nine of the most common angle settings with
positive stops at 0°, 15°, 22.5°, 31.6°, 45° (left) and 0°, 15°,
22.5°, 31.6°, 45°, 60° (right).
To adjust miter angles
•
Loosen the miter lock handle counterclockwise to
unlock the table and squeeze the miter latch lever .
•
Move the table to align the pointer to the desired
degree on miter scale .
•
Release the miter latch lever and tighten the miter
lock handle .
1
Miter angle pointer adjustment
•
Unplug the saw.
•
Move the miter table to the 0° positive stop.
•
Loosen the pointer screw and adjust the indicator
to the 0° mark on the miter scale and retighten the
screw.
Fig. 17
5
4
8
9
1
3
4
2
5
4
3
1
6
7
2
3
Hide quick links:
Advertisement
Table of Contents
