Install 5 ¼-Inch Devices Into The Reorientation Bracket; Installing 5 ¼-Inch Devices - Intel SC5100 - Server Chassis Rack Optimized Hot Swap Redundant Pwr Installation Manual

Install 5 ¼-Inch Devices into the Reorientation Bracket
1. Remove the two screws that hold the EMI shield in place.
2. Remove the EMI shield.
3. Slide the device into the bracket.
4. Insert and tighten the four screws removed when you removed the slide rails.
A
C
22
A. 5 ¼-inch device
B. Screws that hold the device
C. EMI shields
D. Screws that hold the EMI shields
Figure 11. Installing 5 ¼-Inch Devices
Intel SC5100 and SC5200 Rack Kit Installation Guide
B
D
OM12029