Using Autoanswer With A Headset Or Speakerphone - Cisco CP-7931G User Manual

Using AutoAnswer with a Headset or Speakerphone

When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings.
Your system administrator configures AutoAnswer to use either the speakerphone or a headset. You
may use AutoAnswer if you receive a high volume of incoming calls.
If you...
Use AutoAnswer with
a headset
Use AutoAnswer with the
speakerphone
Tip
AutoAnswer is disabled when the Do Not Disturb feature is active.
Cisco Unified IP Phone 7931G Phone Guide for Cisco Unified Communications Manager 8.5(1) (SCCP and SIP)
Then...
Keep headset mode active (in other words, keep
even when you are not on a call.
To keep headset mode active, do the following:
• Press EndCall to hang up.
• Press New Call or Dial to place new calls.
If your phone is set up to use AutoAnswer in headset mode, calls are
automatically answered only if
ring normally and you must manually answer them.
Keep the handset in the cradle and headset mode inactive (
unlit).
Otherwise, calls ring normally and you must answer them manually.
Using a Handset, Headset, and Speakerphone
(
( ) is illuminated. Otherwise, calls
) illuminated),
( )
55