Revolabs Fusion Setup Manual

Hide thumbs Also See for Fusion:

Download this manual

Revolabs Fusion

This setup guide will guide you through the steps needed to properly connect a

Revolabs Fusion Microphone System to a Tandberg C20 video codec.

It is important to carefully follow these instructions in order and completely.

Note:

Otherwise your Fusion Microphone System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding. Con-

tact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Fusion 4 or 8 channel Microphone System

2. Tandberg C20 video codec

3. QTY 1 XLR female to 3.5mm TRRS cable (07-XLRTO35M4-01)

4. QTY 1 RCA male — RCA male cable

5. Amplified Speakers

NOTE:

IMAGES ARE PART OF THE

2009

Microphone System — Tandberg C20 Setup Guide

ANDBERG

C20 A

ODEC

DMINISTRATOR

UIDE

ULY

Need help?

Do you have a question about the Fusion and is the answer not in the manual?

Page 1 It is important to carefully follow these instructions in order and completely. Note: Otherwise your Fusion Microphone System and/or the video codec may not function properly. Please read through these instructions completely before proceeding. Con- tact Revolabs technical support if you have any questions.
Page 2 2. Connect a Male RCA-RCA audio cable between the “CONF IN” port on the Fusion and the White “AUDIO OUTPUT” port on the C20. 3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and the Amplified Speakers.
Page 3 1. Select SETTINGS 2. Select ADVANCED 3. Select ADVANCED CONFIGURATION NOTE: You must use your Fusion remote control to control the room volume for both the audio and video conference calls. Adjusting the volume in the video codec will cause echo.
Page 4 * NOTE: Audio Volume is OUTPUT level only, not INPUT LEVEL. NOTE: You must use your Fusion remote control to control the room volume for both the audio and video conference calls. Adjusting the volume in the video codec will cause echo.