Preparing For Hot Lamination - UNITED OFFICE ULG 300 A1 A3 LAMINATOR Operating Instructions Manual

8. Preparing for hot lamination

➩
Insert the foil guide rails
holes on the rear of the laminator.
➩
Fold out the document supports
documents can be pulled in straight into the slot
for manual foil feed
➩
Insert the plug of the laminator into a mains
power socket.
➩
Provide a firm location for the appliance.
➩
Set the selector switch for hot and cold lamina-
tion to "HOT ".
i
➩
Set the foil thickness switch
thickness (80 or 125 microns). The red ON/OFF
indicator lamp
nator heats itself up to its operating temperature.
• As soon as the green indicator lamp "Ready"
glows, the laminator has reached its
y
operating temperature.
Attainment of the operating temperature
is indicated by the lighting up of the green
LED indicator lamp "Ready"
more uniform laminating result we recom-
mend, especially for thinner foils (below
125 Micron) and after adjustment to a dif-
ferent foil thickness, to first wait an addi-
tional 2-3 minutes before beginning with
lamination.
➩
Lay the document to be laminated into a lami-
nating pouch of the appropriate size.
q in the designated
, so that the
s
.
t
o to the desired foil
will now glow. The lami-
u
. For a
y
Make certain that all corners of the docu-
ment have at least two millimetres of space
to the edge of the laminating pouch, as
shown in Fig. 1. Make certain that you use
only one pouch for laminating. First open
it up, as shown in Fig. 2.
Fig. 1
For information about the lamination
process, please read section 10.
Fig. 2
- 5 -