Unitree Go2 User Manual page 3

1) Go2 can use 5Gwifi band1 channel, 5150-5250MHz indoor use only.
2) When using, please control the robot within sight, keep a certain safe distance from the robot, and do not touch
the robot with your hands after the robot is powered on.
3) When the battery power is only one block left, please stop and turn off the robot dog in time, take out the battery
to charge to avoid the damage of falling when the battery is low.
4) Go2 is a purely electric quadruped robot with certain anti-jamming, but the energy density of the motor is much
lower than the hydraulic pressure. Do not push the robot suddenly and vigorously, nor to kick the robot, so if the robot
falls and is damaged due to a sudden and strong push or kick, it will not be covered by the warranty.
5) To reduce the risk of electric shock and possible radiation hazards, do not disassemble or modify this product
without authorization. This product does not include user-repairable parts. If after-sales service is needed, please contact
Unitree.
6) Go2 LiDAR meets the safety requirements of Class 1 laser products (IEC /EN 60825-1:2014) and can be safely
used under normal conditions.
7) In situations of low air visibility (such as haze, heavy rain, etc.), the effective detection range of Go2 LiDAR will
decrease. Please be extra careful when using.
8) Do not touch the optical window of the Go2 LiDAR with your hands. If there are any stains or dust on the LiDAR
window, please clean it with a lens cleaning cloth (refer to the specific cleaning method in " Daily Maintenance") to avoid
affecting the performance of the product.
9) The robot is not waterproof, please do not run on the ground with water, rain or snow or humid environment. The
robot is not dustproof. Do not run on gravel or dusty environment.
10) Please do not run the robot in an electromagnetic interference environment. Sources of electromagnetic
interference include but are not limited to: high-voltage power lines, high-voltage transmission stations, mobile phone
base stations, and television broadcast towers.
11) Please do not run the robot in the Wi-Fi signal interference environment. Wi-Fi signal interference is usually
caused by co-channel interference. In case of interference, be sure to turn off some or all Wi-Fi signal sources of other
wireless devices before using the remote control to operate the robot.
12) Please keep it under control in the users' view when using the robot and keep the robot maintain a safe distance
of at least 2 meters from obstacles, complex ground, crowds, water, and other objects.
13) Operate in a good weather environment at 5° C -35° C. Do not operate in bad weather, such as fog, snow, rain,
lightning, sandstorms, storms, tornadoes, etc.
14) The legged robot has certain requirements for the ground on which it walks. Do not use the robot on very low
friction ground, such as ice. Do not use the robot on soft ground, such as thick spongy ground. If the robot is used on
smooth ground, such as glass and ceramic tile, the users need to control the robot for movement carefully and smoothly,
avoid violent movement, and reduce the walking speed of the robot to prevent the robot foot from slipping and falling.
© 2023 All rights reserved, Unitree Robotics
3