Changing The Connection During Recording - Yamaha UW500 Owner's Manual

Changing the driver setting (MIDI Patch Screen)
Changing the connection during recording (MIDI IN
You can change the I/O assignment of the computer's input port and the UW500's
input port. The left column shows the computer's input ports (IN 1-2), and the top
column shows the UW500's input ports (1-2). With the default settings, ports with the
same number are connected to each other. However, you can change this setting by
checking the check boxes.
If you check multiple check boxes vertically, a MIDI signal from one input port on the
UW500 is distributed to multiple input ports on the computer. If you check multiple
check boxes horizontally, MIDI signals from multiple input ports on the UW500 are
merged and transmitted to one input port on the computer.
NOTE
Routing MIDI signals from MIDI IN 1 (MIDI IN terminal) and 2 (TO TG terminal)
on the UW500 to the computer's input port 1
Check the check box as shown on the right, and click [OK]
to enable the setting.
48
See page 44 for more information on the relationship between the
UW500's I/O ports and the port numbers.
PC IN)