Yamaha UW500 Owner's Manual page 37

8. On the Track View Window, click a cell in the "Type" column of the
recording track to select "WAVE." If you click a cell in the "Rec" column to
place the corresponding track into record-ready status, an "R" mark
appears in the "Rec" column. If you click the Record button in the Play
Control panel, the button turns red, indicating that the track is in record-
ing stand-by mode.
9. Raise the guitar volume level, and while making sure that the sound
through the headphones is not distorted, adjust the recording level using
the INPUT 1/2 volume knobs. At the same time, use the OUTPUT knob to
adjust the headphones volume level.
NOTE Set the volume levels to maximum in the "Volume Control" dialog box
(page 30). Otherwise, the volume level of the recorded sound may be lower
than the monitoring level.
10. Click the Play button in the Play Control panel. The Play button lights up
and recording starts. While listening to the SoftSynthesizer sound, play
the guitar and record the sound.
Hard Disk Recording
37