Backyard Creations ALLENWOOD BGH07505K07 Manual

IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Step 1: Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or are
unsure how to proceed with assembly, call our
Customer Service Center at 1-800-416-3511.
attempt assembly if any parts are missing or
damaged.
Step 2: Attach the left arm to the back frame by using the
bolts and washers as shown in
Fig. 1
bolts through the holes in the left
pre-drilled holes in the back frame.
Repeat for the right arm.
2-3 revolutions only.
G
E
C1
F
A
Fig. 1
FOOT CAP
Step 3: Attach the seat frame to the arms and back frame
by using the bolts and washers as shown in
Guide the bolts through the holes in the seat frame
and into the pre-drilled holes in the back frame and
the arms. Hand tighten 3-4 revolutions only.
Do not
. Guide the
F
arm, into the
Hand tighten E
G
C2
After making any necessary adjustments to the
Step 4:
alignment of all parts, use the hex bolt driver to
tighten all bolts.
a few revolutions at a time. In order to apply equal
pressure to all bolt joints, we recommend working
in a cross corner (X fashion). Repeat until all bolts
are tight.
may strip bolts. Cover all bolts with covers.
Step 5: With the help of another person, turn the sofa in the
upright position. Your sofa is now ready for use.
you have any questions, please call our
Customer Service Center at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames
.
Fig. 2
resulting from over tightened bolts or improper
assembly is not covered under our warranty. Please
read all instructions carefully before assembly. If you
have any questions regarding your assembly, call our
Customer Service Center at 1-800-416-3511.
B
F
E
G
Fig. 2
Note: each bolt must be tightened
Do not over tighten . Over tightening
If
Page 2
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
PARTS LIST DESCRIPTION
A BACK FRAME
B
SEAT FRAME
C1 LEFT ARM
C2
RIGHT ARM
D HEX BOLT DRIVER
E
1/4" X 18 MM BOLT
Ø6.5 X 1.0 MM
F
WASHER
BOLT COVER
G
FOOT CAP
FACTORY ASSEMBLY
BGH07505K07
ORDER PART # QTY
SH0253 1
1
SH0254
1
SH0256
1
SH0255
1
HW0006
12
HW0035
12
HW0004
12
HW0105
FC0030