Backyard Creations M21050T Assembly Instructions

Wrought Iron 28" Round Mesh Bistro Table
Item #2720700 / M21050T
Assembly Instructions
**TO AVOID POTENTIAL SCRATCHING TO PARTS BY ROUGH GROUND SURFACE, COVER GROUND
WITH SOFT SMOOTH PROTECTIVE MATERIAL ON WHICH TO PLACE PARTS DURING ASSEMBLY. **
Step 1: Remove protective wrapping and lay all parts on ground. Identify all parts packed in carton against the parts
list.
Step 2: Lay Table Top Frame (A) upside down on ground, so bottom is facing up.
Step 3: Then attach each of the three legs(B) to the bottom as shown in Diagram 1, using Bolts(D) and Washers(G).
Attach Stretcher Ring(C) to Legs(B) using Long Bolt(E,F) and Washer(G) as shown in Diagram 2. Tighten bolts with Hex
Wrench(I) after all parts are in place.
Step 4: Make sure all bolts are aligned properly and securely tightened. Then place Bolt Covers(H) over bolts. Turn table
to upright position on flat surface.
NOTE: IT IS USER'S RESPONSIBILITY TO MAKE SURE ALL PARTS ARE ASSEMBLED AND TIGHTENED PROPERLY AND
SECURELY.
WARNING!: TABLE IS NOT MEANT FOR SITTING OR STANDING ON. DO NOT SIT/STAND ON, OR LEAN FULL BODY
AGAINST TABLE. IMPROPER USE MAY LEAD TO PRODUCT DAMAGE AND/OR BODILY INJURY.
B
A
Diagram 1
1 of 2