Yamaha Tyros2 Owner's Manual page 224

Appendix
Installing the Optional DIMMs
4
Insert the two DIMMs into the DIMM sockets.
Location for DIMM installation
Installing the DIMM modules to the sockets
Insert the DIMM vertically in the
socket, aligning the notches to the
corresponding protrusions.
5
Re-install the cover you removed in step #3, in reverse order.
6
Check that the installed DIMMs are functioning properly.
Set the Tyros2 right-side up, and connect the power cord to the rear-panel AC INLET jack and an
AC outlet. Turn on the power and check the WAVE RAM in the PROPERTY pop-up of the Voice
Creator function (page 103). If the DIMMs have been installed properly, the appropriate available
memory size is indicated in the display.
■ Removing DIMMs .............................................................................................
Press the ejector lever
until the DIMM unlocks.
224
Tyros2 Owner's Manual
168-pin DIMMs
↑ Rear panel
(Underside of the Tyros2)
DIMM sockets
Make sure that the DIMM module is
aligned correctly before you install it.
Notch for alignment
Ejector
lever
Press it in firmly until it
"snaps" or locks in place.
Pull the DIMM vertically
out of the socket.