Yamaha Tyros2 Owner's Manual page 17

See page
185.
The TRIM con-
trol allows the
input sensitiv-
ity of the AUX
IN L/L+R and
R (LOOP
RETURN)
jacks to be
adjusted for
optimum level
matching with
the connected
equipment.
These jacks can be used either as AUX OUT or LOOP SEND, and can be selected from the Function menu (page 193).
The sound is output at a fixed level, regardless of the [MASTER VOLUME] control setting. Use the AUX OUT jacks to
output the Tyros2 sound through an external audio system, or to record the sound with an external audio recorder.
Connect the AUX OUT jacks of the Tyros2 to the AUX IN jacks of the audio system using appropriate audio cables.
When these are used as LOOP SEND jacks, you can route the output of the Tyros2 to an external signal processor or
processors, and return the processed signal back to the instrument via the AUX IN/LOOP RETURN jacks—letting you
apply your own favorite effects to the overall sound.
Stereo System
For installing the included
music rest.
See page 19.
The TRIM control allows
the input sensitivity of
the MIC/LINE IN jacks
to be adjusted for opti-
mum level matching
with the connected
equipment.
Example of Loop Send
The LINE OUT jacks are used to send the Tyros2 output to a keyboard
amplifier, stereo sound system, mixing console, or tape recorder. If you are
connecting the Tyros2 to a mono sound system, use only the L/L+R jack.
When only this jack is connected (using a standard phone plug), the left and
right channels are combined and output through this jack—allowing you
have a mono mix of the Tyros2's stereo sound.
Panel Controls and Terminals
For installing an optional
set of speakers.
These jacks can be used either as LINE IN or MIC. The L/
L+R/MIC jack can be connected to any standard microphone
or line-level source with a 1/4" phone plug (a dynamic micro-
phone with an impedance of 250 ohms is recommended). By
connecting an external audio source to the R and L/L+R/MIC
jacks, you can record that source along with your perfor-
mance, using the Hard Disk Recorder function.
Connecting a source only to the L/L+R/MIC jack results in a
mono input. Connecting to both the R and L/L+R/MIC jacks
(or only the R jack) results in a stereo input.
Tyros2 Owner's Manual
See page 18.
IMPORTANT
• See page 18.
See pages 47, 175.
17