Yamaha Tyros2 Owner's Manual page 183

■ Selecting an Effect type and creating a User Effect
Various types of Effects are provided for each Effect Block listed on page 182. Each Effect type can be
edited with the parameters (see the Effect Type Edit display below) and saved as a User Effect Type.
● Effect Type Edit
Select a block to
which the desired
effect type
belongs.
Select a parameter to be edited. Parameters
displayed differ depending on the selected
Effect type. Refer to the separate Data List
booklet for details.
Select an Effect category/type to
be edited.
The value of the parameters when turning the [VARIATION] on
can be set as for the DSP2–5 blocks.
Use these LCD buttons to switch between the upper/lower
parameters. For the lower parameter, the depth can be changed
when the [VARIATION] button is on.
NOTE
• Keep in mind that in some cases noise may result if you adjust
the effect parameters while playing the instrument.
● Effect Type Selection display for each block
Select an Effect Block and a part to
which the corresponding effect is
applied. Please note that a part cannot
be selected if the selected block is used
as a System Effect. See the Effect
Block list on page 181.
● User Effect Type Save
When the edited effect block is
a System Effect, the Effect
Return Level parameter (page
182) can be adjusted here.
Set the value of the param-
eter selected at left.
Select an Effect type after
selecting a category.
Select the destination to which the
effect is to be stored.
The number of memory spaces
available for the destination differs
for each block (page 181).
Tyros2 Owner's Manual
Reference
Mixing Console
Pressing the [SAVE] LCD
button calls up the pop-up
window for entering the
name of the edited Effect
type. Enter the desired
name and press the [OK]
LCD button to save the
edited effect to the location
specified at left.
183