Recalling A Registration Memory Setup - Yamaha Tyros2 Owner's Manual

Quick Guide
Saving and Recalling Custom Panel Setups—Registration Memory
4
Go back to the Registration Memory Bank selection (Open/Save) display and
execute the Save operation.

Recalling a Registration Memory Setup

1
Press both REGIST BANK [-] [+] buttons simultaneously to call up the Regis-
tration Memory Bank selection display.
2
Select a Registration Memory bank.
Selecting a Registration Memory bank is done in the same way as selecting a voice (page 25) or style
(page 31).
Once you've selected a Bank, you can select previous/subsequent Banks in the same folder level by
using the [-]/[+] buttons, even when a display other than the Registration Memory bank display is
shown.
3
Press one of the green-lit numbered buttons in the Registration
Memory section.
■ Leaving certain parameters unchanged by Registration Memory
—Freeze function
Registration Memory lets you recall all the Tyros2 panel settings you made with a single button press.
However, there may be times that you want certain parameters and settings to remain the same, even
when changing Registration Memory presets. For example, you may want to switch voices or effect
settings while keeping the same accompaniment style. This is where the Freeze function comes in handy.
It lets you maintain the settings of certain parameter groups and leave them unchanged, even when
selecting other Registration Memory buttons.
1
Select the parameter group you want left unchanged or "frozen" (page 173).
2
Turn the [FREEZE] button on.
3
Change the Registration Memory number.
■ Calling up Registration Memory numbers in order
—Registration Sequence
As convenient as the Registration Memory buttons are, there may be times during a performance when
you want to quickly switch between settings—without having to take your hands from the keyboard. By
assigning a footswitch to control Registration Sequence, you can use your foot to step through the Reg-
istration Memory presets—in the order you've specified.
54
Tyros2 Owner's Manual
The pop-up window for entering the
name of the Registration Memory Bank
appears at the bottom of the display.
After entering the name, press the [OK]
LCD button (upper [8] button) to save
the bank name and eight panel setups to
the User drive.
For instructions on entering names,
see page 76.
.....................................................................................................page 173
......................................................................................page 173
• When an audio song recorded by
the Hard Disk Recorder is regis-
Confirm whether the cor-
tered, the song may take a few
rect panel settings have
moments to load.
been called up or not.
NOTE