Problem Solving - Xact XG2201 Instruction Manual

Problem Solving

Problem Solving Section
For your assistance, we have listed below a few common problems.
Phone does not work, check the following:
1. BASE UNIT is plugged into a power source.
2. HANDSET is charged.
3. TONE/PULSE Select switch is in the right position.
4. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK.
Range of phone limited, check the following:
1. BASE UNIT is centrally located in your residence.
2. BASE UNIT is not located near appliances.
No dial tone, check the following:
1. TELEPHONE LINE CORD plugs are connected to the TELEPHONE JACK and TELEPHONE LINE CONNECTION JACK.
2. BASE UNIT is plugged into a power source.
3. If you had a power failure or had unplugged the BASE UNIT, replace the HANDSET on the BASE UNIT for 2 to 5 seconds to
reset the system.
Received signal flutters or fades, check the following:
1. BATTERY PACK in the HANDSET is fully charged.
2. HANDSET is not too far from the BASE UNIT.
Interference on reception, check the following:
1. Noise may be picked up from electrical products in the home or electrical storms. Generally, this noise is a minor annoyance
and should not be interpreted as a defect in your system. (See Technical Information on page 32.)
2. Choose an alternate channel using the
3. Do not use this telephone within 20 ft. of a microwave oven while it is working, as you may experience interference. This is a
normal occurrence with 2.4 GHz phones and should not be interpreted as a defect in the product.
Long Distance "L-D-C" indicator is not ON when receiving a long distance call, check the following:
1. Your local telephone company can provide the Area Code on an incoming long distance call.
Excess static, check the following:
1. Check to see that the ANTENNA is not touching another metal object.
If after pressing the
TALK
1. BASE UNIT is plugged into a power source.
2. If you had a power failure or had unplugged the BASE UNIT, replace the HANDSET on the BASE UNIT for 2 to 5 seconds to
reset the system.
NOTE: If none of telephones in the house are working, disconnect one set at a time to verify that none of the phones are causing
the problem. If you still have a problem after doing this, and your telephone still does not work, please contact your local
phone company.
button on the HANDSET.
DELETE
SCAN
button, you receive three "beeps" and no dial tone, check the following:
31