Battery Type; Recharging The Battery Pack - Xact XG2201 Instruction Manual

Recharging the BATTERY PACK

Battery Type

Use the following type and size of BATTERY PACK:
Cordless Telephone BATTERY PACK
3.6V, 600mAh
XACT Communication
Ni-MH Battery Pack: Model B655
This BATTERY PACK is available through:
XACT Communication Service Center
105 Madison Avenue
New York, NY 10016
1-866-466-XACT (9228)
Recharging the Battery Pack
The nickel metal hydride (Ni-MH) BATTERY PACK in the HANDSET can be recharged many times using the built-in charger in the
BASE UNIT.
When the BATT LOW symbol appears on the LCD Screen, a "beep" sound will be heard every 10 seconds. This indicates that the
BATTERY PACK needs to be recharged.
Charge the BATTERY PACK at least once every 90 days of non-use to avoid battery failure. When the BATTERY PACK can no
longer be charged, replacement of the BATTERY PACK will be necessary.
The BATTERY PACK used in your telephone may develop a condition known as "MEMORY". Once subjected to a regular short
discharging routine, the BATTERY PACK assumes the discharging pattern it was subjected to. This is known as a "MEMORY"
condition which causes rapid discharging thereby shortening the BATTERY PACK charge span. If you believe your BATTERY
PACK has developed a "MEMORY" condition, do not charge the HANDSET until the BATT LOW symbol appears on the LCD
Screen. When the BATT LOW symbol appears on the LCD Screen, charge the HANDSET fully for 12 hours.
In order to get maximum life from the HANDSET BATTERY PACK, be sure to
charge the HANDSET for 12 hours before initial use.
NOTES: 1. During a power interruption, the BASE UNIT
does not operate, and a phone conversation
cannot be made on the HANDSET.
2. A "beep" will be heard when the HANDSET is
properly positioned in the BASE UNIT
CHARGE CRADLE and charging. Securely
positioning the HANDSET, KEYPAD face up, in
the BASE UNIT will also prevent the HANDSET
from falling.
IMPORTANT
29