Headset Feature; Redial Feature - Xact XG2201 Instruction Manual

Cordless Telephone Operation

Headset Feature

Your telephone can utilize a headset (not included) to be connected to your HANDSET for you to
enjoy hands-free communication. Pull out the HEADSET JACK COVER, then insert the small plug
at the end of the headset into the HEADSET JACK at the left side of the HANDSET. Follow the
procedures discussed in "Receiving Calls" and "Placing Calls" to receive and place a call.
NOTE: When you plug the headset plug into the HEADSET JACK it automatically mutes the
MICROPHONE and SPEAKER of the HANDSET. Unplug the headset to return the
HANDSET to normal use.
Headsets are available at most retail outlets that sell telephone equipment. The HEADSET JACK
is compatible with 2.5 mm headset plugs only.

Redial Feature

1. If you get a busy tone, press the
hang up.
2. Later, press the button again.
TALK
3. Listen for a dial tone.
4. Press the button. This will automatically redial the last telephone number you called in
RE/PA
SAVE
TALK mode.
5. When you have finished with your call, either press the
IN USE LED indicator will turn off) or place the HANDSET on the BASE UNIT.
NOTE:
If you are too far away from the BASE UNIT, the HANDSET emits "beep" sounds to warn you that the background noise level is
too high for proper communication between the HANDSET and the BASE UNIT. When you hear this sound, you should move
closer to the BASE UNIT to reduce the noise level. Otherwise, the call will automatically cut off.
button or place the HANDSET on the BASE UNIT to
TALK
TALK
13
button again (the BASE UNIT