Vivotek IP7161 User Manual page 73

Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, the Preset Position and PTZ Control
Panel on the main page will be disabled� You will need to configure command buttons to control the PTZ
scanner� Click Custom Command to open the Custom Command page to set the commands in the
Control Settings session� Please refer to your PTZ scanner user's manual to enter the commands in the
following fields. Click Save to enable the settings and click Close to exit the page�
►The command buttons will be displayed on the main page:
NOTE
►If you select DynaDome/SmartDOME, Lilin
PIH-7x00, or Pelco D protocol as the PTZ
driver, the Control Settings column will not
be displayed�
►For all PTZ drivers, a total of five additional
command buttons can be configured.
VIVOTEK
User's Manual - 73