Vivotek IP7153 Quick Installation Manual
  1. Manuals
  2. Brands
  3. Vivotek Manuals
  4. Security Camera
  5. IP7153
  6. Quick installation manual
Vivotek IP7153 Quick Installation Manual

Vivotek IP7153 Quick Installation Manual

Progressive scan ccd network camera
Hide thumbs Also See for IP7153:
Table of Contents

Advertisement

Quick Links

Download this manual See also: User Manual

Advertisement

Table of Contents
loading

Related Manuals for Vivotek IP7153

Summary of Contents for Vivotek IP7153

  • Page 2 Warning Before Installation Power off the Network Camera as Keep the Network Camera away from soon as smoke or unusual odors water. If the Network Camera becomes are detected. wet, power off immediately. Contact your distributor in the event of Contact your distributor in the event of occurrence.
  • Page 3 Do not touch the Network Camera Do not place the Network Camera on unsteady surfaces. during a lightning storm. Do not disassemble the Network Do not drop the Network Camera. Camera. Do not insert sharp or tiny objects into the Network Camera. EN - 2...

  • Page 4: Check Package Contents

    Check Package Contents IP7153 / IP7154 Power Adapter Camera Stand Lens Software CD Quick Installation Guide ST7501 Central Management Software Warranty Card Antenna (IP7154 only) EN - 3...

  • Page 5: Physical Description

    Physical Description Front Panel Antenna (IP7154 only) Light Sensor Built-in Microphone Status LED Back Panel Antenna (IP7154 only) External/Internal Microphone Switch Audio Out Microphone In Ethernet 10/100 Power Cord Socket RJ45 Socket General I/O Recessed Reset Button Terminal Block Lens Focus Controller Zoom Controller EN - 4...

  • Page 6: Mounting The Lens To The Camera

    Mounting the Lens to the Camera 1. Mount the lens by turning it clockwise onto the camera mount until it stops. If necessary, turn the lens counterclockwise slowly to achieve the best optimum spacing. 2. Connect the lens cable plug to the camera connector. 3.

  • Page 7: Network Deployment

    Network Deployment General Connection (without PoE) 1. Connect the camera to a switch via Ethernet cable. 2. Connect the power cable from the Network Camera to a power outlet. Ethernet Switch EN - 6...
  • Page 8 Power over Ethernet (PoE) (IP7153 only) When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-enabled switch via Ethernet cable.

  • Page 9: Assigning An Ip Address

    "Next" button to continue the program. Installation Wizard 2 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. 4. After searching, the main installer window will pop up. Click on the MAC that matches the one labeled on the bottom of your device to connect to the Network Camera via Internet Explorer.

  • Page 10: Ready To Use

    Ready to Use 1. Access the Network Camera on the LAN. 2. Retrieve live video through the web browser or recording software. For further setup, please refer to user's manual on the software CD. EN - 9...
  • Page 11 Confi gure the Wireless Connection (IP7154 only) 1. Check the SSID for your wireless access point (AP). 2. Go to the IP7154 Confi guration page > Advanced mode > Wireless LAN. 3. Type in the SSID the same as your AP. 4.
  • Page 12 P/N: 625009000G Ver.1.01 Copyright 2009 VIVOTEK INC. All right reserved.

This manual is also suitable for:

Ip7154

Table of Contents