Warning Before Install Power off the Network Camera Keep the Network Camera away as soon as it is found smoking or from water. If the Network Camera smelt unusual. is wet, power off immediately. Contact your distributor when such Contact your distributor when such cases happen.
Page 3
Do not place the Network Camera Do not touch the Network Camera on unsteady surfaces. when it’s lightening. Do not disassemble the Network Do not drop the Network Camera. Camera. Do not insert any object into the Network Camera, such as needles.
Physical Description Front panel Light sensor Lens Built-in microphone Back panel Audio out Status LED SD/SDHC card slot Microphone in Ethernet 10/100 Power cord socket RJ45 socket General I/O terminal block Indented reset button External/Internal MIC switch Lens Focus controller Zoom controller...
Mounting the Lens to the Camera 1. Mount the lens by turning it clockwise onto the camera mount until it stops. If necessary, turn the lens counterclockwise slowly until it gets the best attitude. 2. Connect the lens cable plug to the camera connector. For further setup, please refer to the lens’...
Page 7
Power over Ethernet (PoE) When using a PoE-enabled switch The camera is PoE-compliant, allowing transmission of power and data via single Ethernet cable. See the following illustration to connect the camera to a PoE- enabled switch via Ethernet cable. PoE switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the camera and a non- PoE switch.
"Next" button to continue the program. Installation Wizard 2 3. The program will search the VIVOTEK Video Receivers, Video Servers or Network Cameras on the same LAN. 4. After searching, the main installer window will pop up. Click on the MAC that matches the one labeled on the bottom of your device to connect the Internet Explorer to the Network Camera.
Ready to Use 1. Access to the Network Camera from the Internet. 2. Retrieve live video through web browsers or recording software. 3. Unscrew the zoom controller to adjust the zoom factor. Upon completion, tighten the zoom controller. 4. Unscrew the focus controller to adjust the focus range. Upon completion, tighten the focus controller.
Fine-tune the Camera Focus Please follow the steps below to ¿ ne-tune the camera focus: 1. Use the supplied L-type hex key wrench to loosen the ring screw; the adjusting ring will become rotatable. 2. Rotate the adjusting ring to ¿ ne-tune the distance between the sensor and the lens;...