Network Deployment - Vivotek FD7141 User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Ceiling mount without the bottom base (Embedded)
1� Attach the supplied ceiling hole template sticker to the ceiling�
2� Open a hole along the inner circle of the sticker�
3� Using the 3 circles on the sticker, drill 3 pilot holes into the ceiling� Then hammer the three
supplied plastic anchors into the holes�
4� Mount the Network Camera to the ceiling and feed the cables through�
5� Using the three holes on the side of the camera base, insert the three supplied screws into
the corresponding holes and secure them with a screwdriver�
1
Drill hole
Ceiling Hole Template Sticker

Network Deployment

Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to an Internet
1� If you have external devices such as sensors and alarms, make the connection from the
general I/O terminal block�
2� Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use a Category 5 Cross Cable when Network Camera is directly connected to PC�
3� Connect the power cable from the Network Camera to a power outlet�
1
N�C�: No Connector
N.C.
N�C�: No Connector
N.C.
N�C�: No Connector
N.C.
AC24V
AC24V: Power in AC 24V
AC24V
AC24V: Power in AC 24V
GND: Ground
GND
D I : Digital Input
DI
DO
D O : Digital Output
+12V
+12V : Power, 12V DC
10 - User's Manual
3
2
4
connection�
5
2
3