Audio Settings - Vivotek FD7141 User Manual

Vivotek fd7141: user guide
Hide thumbs Also See for FD7141:
Table of Contents

Advertisement

IR cut filter
With a removable IR-cut filter and built-in IR illuminators effective up to 15m, this Network Camera can
automatically remove the filter and turn on the IR illuminators to let IR light into the sensor during low
light conditions�
■ Auto mode
The Network Camera automatically removes the filter by judging the level of ambient light.
■ Day mode
In day mode, the Network Camera switches on the IR cut filter at all times to block infrared light from
reaching the sensor so that the colors will not be distorted�
■ Night mode
In night mode, the Network Camera switches off the IR cut filter at all times for the sensor to accept
infrared light, thus helping to improve low light sensitivity�
■ Schedule mode
The Network Camera switches between day mode and night mode based on a specified schedule.
Enter the start and end time for day mode� Note that the time format is [hh:mm] and is expressed in
24-hour clock time� By default, the start and end time of day mode are set to 07:00 and 18:00�
Light sensor sensitivity
Select Low, Normal, or High for the light sensor sensibility�
Disable IR LED
If you do not want to use the IR illuminators, you can select this option to turn it off�

Audio Settings

Mute: Select this option to disable audio transmission from the Network Camera to all clients� Note that
if mute mode is turned on, no audio data will be transmitted even if audio transmission is enabled on the
Client Settings page� In that case, the following message is displayed:
External microphone input: Select the gain of the external audio input according to ambient conditions�
Adjust the gain from +21 db (most sensitive) or -33 db (least sensitive)�
Audio type: Select audio codec AAC or GSM-AMR and the bit rate�
■ AAC provides good sound quality at the cost of higher bandwidth consumption. The bit rates are
selectable from: 16Kbps, 32Kbps, 48Kbps, 64Kbps, 96Kbps, and 128Kbps�
■ GSM-ARM is designed to optimize speech quality and requires less bandwidth. The bit rates are
selectable from: 4�75Kbps, 5�15Kbps, 5�90Kbps, 6�7Kbps, 7�4Kbps, 7�95Kbps,10�2Kbps, and
12�2Kbps�
When completed with the settings on this page, click Save to enable the settings�
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
User's Manual - 59

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fd7141v

Table of Contents