CanyCom SC75PD Operator's Manual page 54

• Dispose of the drained oil properly, according to the national and local regula-
tions.
Inspection Plug
3570M-0507-060E
Drain Plug
3570M-0507-070E
3570M-0507-080E
Maintenance
Filler Cap
Inspecting
1. Park the machine on a level ground.
2. Remove the inspection plug and inspect if
the oil level is at the inspection hole. Fill oil if
the level is low.
3. Visually inspect the condition of the oil. If
dirty, change it.
4. Visually inspect the seal washer on the
inspection plug.
5. C l e a n t h e i n s p e c t i o n p l u g a n d s e a l
washer. Put the inspection plug back in the
inspection hole and tighten it securely.
Draining
1. Have an appropriate oil drain pan.
2. Remove the back panel. (Page 35)
3. Remove the drain plug to drain the oil.
4. Put the drain plug back in place and tighten it
securely.
Filling
1. Remove the back panel. (Page 35)
2. Remove the filler cap and fill a sufficient
amount of oil.
3. Inspect the oil level.
4. Put the filler cap back in place.
5. Install the back panel. (Page 35)
NOTE
• Oil Capacity: 2.0L (2.11 US qts.)
-45-
5