CanyCom SC75PD Operator's Manual page 47

5
Upper Limit
3570M-0506-020E
Oil Filler Cap
3570M-0506-030E
Drain Plug
3570M-0506-040E
Maintenance
Lower Limit
3. Pull out the dip stick. Wipe oil off of the
dipstick with clean cloth.
4. Insert the dipstick and pull it out again.
5. Check oil level. Oil level should be between
the two dimples indicating the upper and
lower limits. If the level is low, fill oil.
6. Visually inspect oil. If oil is dirty or its
viscosity is not normal, change it.
NOTE
• To obtain correct reading, check oil level
before starting, or wait about 10 minutes
after stopping the engine to allow oil to
drain back to the oil pan.
• Always check oil level on a level surface.
Filling
1. Remove the oil filler cap.
2. Follow the instructions in the Operator's
Manual for the engine to fill oil.
3. Check oil level.
4. Put the oil filler cap back in place and tighten
it securely.
Changing
1. Have an appropriate oil drain pan.
2. Remove the drain plug to drain oil.
3. Put the drain plug back in place and tighten it
securely.
4. Fill oil.
NOTE
• Oil Capacity: 1.4L(1.48US qts.) [1.55L
(1.64 US qts.) when changing the oil filter
cartridge.
• Removing the oil filler cap helps drain oil
faster.
-38-