Positioning And Securing Your Child Without Backrest And Lap-Shoulder Belt Only - Britax PARKWAY SGL User Manual

Positioning the Booster Seat
Positioning and Securing Your Child without
Backrest and Lap-shoulder Belt Only
BEFORE YOU BEgIN:
9 If the vehicle seat back is adjustable, ensure it is in the upright
position before placing the booster seat on the vehicle seat.
9 Ensure the booster seat is positioned in a location that has a
vehicle head restraint.
Note: Before using the booster seat without the backrest, you
may need to complete the removal instructions on page 15.
Place the booster seat base on the vehicle
1
seat and push it back against the vehicle
seat back.
Sit your child in the booster seat.
2
Pull the vehicle seat belt out from the
3
retractor, positioning the lap belt under both
armrests and over both red belt guides
(Fig. A).
Verify that the vehicle seat belt is not
4
twisted and then fasten across the child.
Adjust the vehicle seat belt's shoulder part
5
so that it crosses the chest and center of
the child's collar bone (Fig. B).
30
6
7
a
b
Positioning the Booster Seat
Route the lap part of the vehicle seat belt
through the SecureGuard™ clip (Fig. C).
* The lap part of the vehicle seat belt
should rest low on the child's upper
thighs.
Remove slack from the vehicle seat belt.
* The shoulder part should cross the chest
in the center of the child's collar bone.
Checklist
9 Vehicle seat belt is not twisted
9 Vehicle seat belt is securely fastened
9 Lap part of the vehicle belt is routed through the SecureGuard™ clip
9 Vehicle seat belt is properly positioned low across the child's upper
thighs and does not contact the child's neck
c
31