Using the Child Seat
SecureGuard™
Britax recommends using SecureGuard to
achieve the best vehicle seat belt placement.
The SecureGuard™ clip should hold the lap
part of the vehicle seat belt in place. The
SecureGuard™ clip should be adjusted to keep
the lap part of the vehicle seat belt positioned
low across your child's upper thighs (Fig. A).
Ensure the bottom edge of the SecureGuard™
clip is level with your child's upper thighs,
however, the clip itself should not press into
your child's upper thighs.
The lap part of the vehicle
IMPORTANT:
seat belt must not rest on the child's
abdomen.
Adjusting SecureGuard™ Fit
• To Shorten:
1 Locate the SecureGuard
under the base. See page 13.
2 Pull the SecureGuard
™
from the base.
3 Feed the webbing through the
SecureGuard
adjuster (Fig. B).
™
4 Pull the end of the SecureGuard
tighten (Fig. C).
• To Lengthen:
1 Locate the SecureGuard
page 13.
20
a
b
adjuster
™
adjuster away
c
adjuster webbing to
™
adjuster under the base. See
™
2 Pull the SecureGuard
™
from the base.
3 Feed the end of the SecureGuard
webbing through the SecureGuard
adjuster (Fig. D).
4 Pull the webbing to remove slack from
the SecureGuard
adjuster.
™
5 Move the SecureGuard
™
SecureGuard
webbing.
™
The lower edge of the SecureGuard
the child's upper thighs once they have been secured in the
booster seat.
Using the Retractable Cup Holders
Pull the cup holder out from
the booster base to use.
IMPORTANT:
• DO NOT
use with hot liquids.
• DO NOT
step on or put excess weight on the cup holder.
Using the Child Seat
adjuster away
™
™
d
clip to the center of the
clip should be level with
™
Push the cup holder into the
booster base to store.
21