Britax PARKWAY SGL User Manual page 15

Positioning the Booster Seat
NOTE: If a click is not heard when
connecting the lower connectors, the
lower connector strap may be twisted
or there may be debris in the lower
connector. Correct either situation
before continuing with the positioning
process.
Ensure that the booster seat is
5
positioned correctly on the vehicle
seat (Fig. D). Guide the seat into
place while pulling the ISOFLEX™
adjuster strap on either side of the
booster to remove slack (Fig. E).
NOTE: Only tighten until the slack is
removed from the strap.
Sit your child in the booster seat.
6
Pull the vehicle seat belt out, positioning
7
the lap belt under both armrests and over
both red belt guides (Fig. F).
Verify that the vehicle seat belt is not
8
twisted and then fasten.
Adjust the vehicle seat belt's shoulder part
9
so that it crosses the chest and center of
the child's collar bone.
26
d
e
f
Route the lap part of the vehicle seat belt
10
through the SecureGuard™ clip (Fig. G).
* The lap part of the vehicle seat belt
should rest low on the child's upper
thighs.
Remove slack from the vehicle seat belt.
11
* The shoulder part should cross the chest
in the center of the child's collar bone
(Fig. H).
Checklist
9 Vehicle seat belt is not twisted
9 Vehicle seat belt is securely fastened
9 Lap part of the vehicle belt is routed through the SecureGuard™ clip
9 Vehicle seat belt is properly positioned low across the child's upper
thighs and does not contact the child's neck
9 If the lower connectors in your vehicle prevent proper vehicle belt fit
across your child you cannot use the lower anchors to position this
booster seat
Positioning the Booster Seat
g
h
27