Secureguard; Adjusting Secureguard Fit; Using The Retractable Cup Holders - Britax Parkway SG User Manual

Using the Child Seat

SecureGuard™

Britax recommends using the SecureGuard to
achieve best vehicle seat belt placement. The
SecureGuard clip should hold the lap part of
the vehicle seat belt in place. The SecureGuard
clip should be adjusted to keep the lap part of
the vehicle seat belt positioned low across your
child's upper thighs (Fig. A). Ensure the bottom
edge of the SecureGuard clip is level with your
child's upper thighs, however, the clip itself
should not press into your child's upper thighs.
The lap part of the vehicle
IMPORTANT:
seat belt must not rest on the child's
abdomen.

Adjusting SecureGuard Fit

To Shorten:
1 Locate the SecureGuard adjuster under
the base. See page 13.
2 Pull the SecureGuard adjuster away
from the base.
3 Feed the webbing through the
SecureGuard adjuster (Fig. B).
4 Pull the end of the SecureGuard adjuster webbing to
tighten (Fig. C).
To Lengthen:
1 Locate the SecureGuard adjuster under the base. See
page 13.
2 Pull the SecureGuard adjuster away from the base.
18
3 Feed the end of the SecureGuard
4 Pull the webbing to remove slack from
a
5 Move the SecureGuard clip to the
The lower edge of the SecureGuard clip should be level with
the child's upper thighs once they have been secured in the
booster seat.
b

Using the Retractable Cup Holders

c
Pull the cup holder out from
the booster base to use.
IMPORTANT:
adjuster webbing through the
SecureGuard adjuster (Fig. D).
the SecureGuard adjuster.
center of the SecureGuard webbing.
• DO NOT use with hot liquids.
• DO NOT step on or put excess weight on the cup holder.
Using the Child Seat
d
Push the cup holder into the
booster base to store.
19