Secureguard - Britax HIGHPOINT User Manual

Britax Child Safety, Inc.
Adjusting Head Restraint Height
The head restraint can be adjusted and locked into different
positions� Check the fit with a child seated in the booster seat�
Ensure that the shoulder belt guides are at or just above the child's
shoulder as shown on page 8�
1� Squeeze and hold the head restraint height adjuster to raise or
lower the head restraint�
2� Slide the head restraint up or down to the desired level�
3� Release the adjustment handle, then pull up to ensure the head
restraint has locked into place�
NOTE: Repeat this process until the shoulder belt lies across the
center of the child's chest and is positioned at or just above the
child's shoulder when positioned through the shoulder belt guide.
10

SecureGuard

Britax recommends using the SecureGuard to achieve best vehicle seat
belt placement� The SecureGuard clip should hold the lap part of the
vehicle seat belt in place�
The SecureGuard clip should be adjusted to keep the lap part of the
vehicle seat belt positioned low across your child's upper thighs� Ensure
the bottom edge of the SecureGuard clip is level with your child's upper
thighs; however, the clip itself should not press into your child's upper
thighs�
IMPORTANT: The lap part of the vehicle seat belt must not rest on the
child's abdomen�
Adjusting the SecureGuard
1� Remove the SecureGuard clip�
a� Lift up the front of the base cover by removing the elastics
at the front of the base (see page 26)�
b� Locate the SecureGuard adjuster and rotate adjuster strap
90 degrees�
c� Slide the SecureGuard adjuster through the slot and pull
through the opening and away from the base�
HIGHPOINT User Guide
11