Multitech MultiModem II MT5600BA-V92-NAM User Manual page 36

Assigning Callback Phone Numbers
AT Command Method
1. Open a data communication program, such as HyperTerminal.
2. To store a callback phone number in the first memory location, type
3. To store a callback phone number in the second memory location, type
4. Repeat as many times as necessary, through memory location 30, until all dialing strings
Front Panel Method
1. Turn on the modem.
2. Starting at the STATUS LCD, press the following buttons on the front panel:
3. Press the Enter button on the front panel to select memory location 1. The
4. Press the
5. Press the
6. The number can be up to 30 characters in length. Repeat steps 4 and 5 until the number is
7. Press the Enter button again to go to the CALLBACK NUMBER LCD.
8. Press
9. Repeat steps 3–7 to enter the next number.
10. Repeat as many times as necessary, up to memory location 30, until all numbers have been
Warning:
attempt to look at a number entry by pressing the Enter button for an ENTER NUMBER #n?
LCD, it is possible for you to accidentally erase the entry.
Multi-Tech Systems, Inc. MT5600BA-V92 User Guide
Downloaded from Elcodis.com electronic components distributor
AT#CBN01=xxxxxxxxxx, where xxxxxxxxxx is the dialing string, and press E
dialing string can include the digits 0 through 9 and any of the following characters: #, *,
comma (,), semicolon (;), W, A, B, C, and D. Up to 30 characters can be used. Example:
AT#CBN01=9,16127853000.
If a direct connection with password protection, but without hangup and callback, is desired,
the first character in the dialing string should be a hyphen (-).
AT#CBN02=xxxxxxxxxx, where xxxxxxxxxx is the dialing string, and press E
the memory location number in the command is incremented by one.
have been entered.
, , , . The ENTER NUMBER #1? LCD appears.
ENTER NUMBER LCD appears.
or button several times to select the first character. If a direct connection,
without hangup and callback, is desired, the first character in the dialing string should be a
hyphen (-).
button to go to the next character in the dialing string.
Note: To backspace or to cancel an entry, press
entered, and then press the Enter button to store it. The NUMBER STORED LCD should
appear.
, to go to the ENTER NUMBER #2? LCD.
entered.
There is no way to review an entry to confirm that it has been entered correctly. If you
Chapter 6 – Callback Security
NTER
NTER
several times.
. The
. Note that
, , , , ,
36