Uio-256 Input/Output Frame; Connecting A Single Uio-256 Frame; Connecting Additional Uio-256 Frames; Programming The Uio-256 - RTS KP-12 System Installation Manual

UIO-256 Input/Output Frame

UIO-256 Input/Output Frame

Connecting a single UIO-256 Frame

Connect a single UIO-256 to J3 of the Master Controller Breakout Panel, as shown in ADAM-101 through ADAM-108
1.
interconnect diagrams starting on page X. Use a RS-485 data cable wired as shown in the ADAM -809 installation drawing
on page 53. If a PAP is also being used, it may be wired to the same connector. Alternatively, use a punch block or other
connector system.
Set the SW-1 DIP switch on the back of the UIO-256 to select a range 1-16, as shown in Table 7 on page 15.
2.
The SW-2 DIP switches are not used, and their positions do not matter.
Connect relay outputs to external devices using the relay outputs connector, J5.
3.
The J5 connector pinout is shown in Table 8 on page 16.
Connect the input devices using the opto-isolator connector, J7.
4.
The connector pinout is shown in Table 9 on page 16.

Connecting Additional UIO-256 Frames

Up to 15 additional UIO-256 frames may be connected in a parallel bus configuration using the 15-pin ribbon cables
1.
provided.
Connect the J3 output of the ADAM MC to the UIO-256 via J2 on the UIO-256.
2.
Connect J2 output of the first UIO-256 to the J2 input of the second UIO-256.
3.
Connect the J2 output of the second UIO-256 to the J2 input of the third.
4.
Repeat as necessary
Set the SW1 DIP switches on each UIO-256 to select a unique panel number as summarized in Table 7 on page 15.
5.
Connect to the opto-isolator outputs and relay inputs as for the first UIO-256.
6.

Programming the UIO-256

Each opto-isolator input is assignable in the GPI Assignments table of AZedit. The GPI Assignment table allows you to
simulate a key on a keypanel at a particular intercom port, regardless of whether or not there is an actual keypanel connected to
that port.
If an input has been assigned to a key, it is then necessary to define a device to be activated by that key. This is accomplished
in the keypanel edit screen for the port to which the digital input was assigned.
The UIO-256 relay outputs are programmed using the GPI Output Edit screen in AZedit.
25