Table of Contents
Advertisement
Chassis Intrusion
The Chassis Intrusion header is des-
ignated JL1. Attach an appropriate
cable from the chassis to inform you
of a chassis intrusion when the chas-
sis is opened
Wake-On-LAN
The Wake-On-LAN header is des-
ignated JWOL1 on the serverboard.
See the table on the right for pin
defi nitions. You must also have a LAN
card with a Wake-On-LAN connector
and cable to use this feature.
Wake-On-Ring
The Wake-On-Ring header is desig-
nated JWOR1. This function allows
your computer to receive and be
"awakened" by an incoming call when
in the suspend state. See the table on
the right for pin defi nitions. You must
also have a WOR card and cable to
use this feature.
Power Supply Fail LED
Connect a cable from your power
supply to J3P1 to provide warning of
power supply failure. This warning sig-
nal is passed through the PWR_LED
pin to indicate of a power failure on the
chassis. See the table on the right for
pin defi nitions.
GLAN1/2 (Ethernet Ports)
Two Ethernet ports (designated GLAN1
and GLAN2) are located beside the
VGA port on the I/O backplane. These
ports accept RJ45 type cables.
Chapter 5: Advanced Serverboard Setup
Chassis Intrusion
Pin Defi nitions (JL1)
Pin#
1
2
Pin#
1
2
3
Pin#
1
2
PWR Supply Fail LED
Pin Defi nitions (J3P1)
Pin#
1
2
3
4
Note: This feature is only available when us-
ing Supermicro redundant power supplies.
5-15
Defi nition
Intrusion Input
Ground
Wake-On-LAN
Pin Defi nitions
(JWOL1)
Defi nition
+5V Standby
Ground
Wake-up
Wake-On-Ring
Pin Defi nitions
(JWOR1)
Defi nition
Ground (Black)
Wake-up
Defi nition
PWR 1: Fail
PWR 2: Fail
PWR 3: Fail
Signal: Alarm Reset
Advertisement
Table of Contents
