K-array Thunder-KS I User Manual page 4

Thunder-KS I
USER GUIDE
• Use only speaker cables for connecting speakers to the speaker terminals.
Be sure to observe the amplifier's rated load impedance particularly when
connecting speakers in parallel. Connecting an impedance load outside the
amplifier's rated range can damage the apparatus.
• K-array cannot be held responsible for damage caused by improper use of the
loudspeakers.
• K-array will not shoulder any responsibilities for products modified without prior
authorization.
FCC Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician
for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment must be
installed and operated in accordance with provided instructions
and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons.
2
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
CAUTION! Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
Canadian Statement
This device complies with Industry Canada's licence-exempt
RSSs. Operation is subject to the following two conditions:
this device may not cause interference, and
this device must accept any interference, including interference
that may cause undesired operation of the device.
The device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 102 and compliance with RSS-102
RF exposure, users can obtain Canadian information on RF
exposure and compliance.
This equipment should be installed and operated with a
minimum distance of 20 centimeters between the radiator and
your body.
CE Statement
K-array declares that this device is in compliance with applicable CE
standards and regulations. Before putting the device into operation,
please observe the respective country-specific regulations!
Trademark Notice
All trademarks are the property of their respective owners.