Sigma Controls Myriad TPC LITE Instruction Manual page 6

WIRING DETAIL
 Inputs, see Dwg # 05-217-1
 Outputs, see Dwg # 05-217-2
All electrical wiring must be in accordance with all local state and
national codes that apply.
!
Do not exceed the rated current of the D.C. power supply (100MA) or
the form 'C' relay outputs (5A/240VAC resistive).
CAUTION
WARNING
The range selector switches located on the bottom of the circuit
board are factory set. If a field change of input type is required see
!
Appendix 'A'. Do not apply an input signal that is not coordinated with
range switches or the unit may be damaged.
CAUTION
Hazardous voltages are present within the enclosure. Installation or
service should only be carried out by trained personnel.
6