Sigma Controls Myriad TPC LITE Instruction Manual page 19

ALARMS
NOTE: In this menu item, all alarm screens will be shown in an automatically 'SCROLLING'
fashion. The following alarm status will appear on the screen:
Any alarm that is currently active will be indicated on its screen by the lower display changing
from 'NOT ACTIVE' to 'ACTIVE'. Any 'ACTIVE' alarm must be reset by selecting 'RESET' with
the   arrows and pressing 'ENTER' after the causal condition has been removed.
NOTE: The RESET function can be utilized from the PASSWORD screen, The ALARM screen,
or by pressing the   buttons simultaneously.
NOTE: While in the main display any alarm condition which occurs during normal operation will
cause a time and date 'stamped' message to pop-up over the main display screen indicating the
specific alarm condition. The on board horn will sound. To clear the screen and stop the horn,
press any key.
On the main display a
indicator will be removed after the alarm has been cleared as described above. The 'RESET'
selection appears on the 'ALARMS' and the 'ENTER PASSWORD' screens.
Pump 1 Failure
Pump 2 Failure
Pump 3 Failure
Seal Leak Alarm
High Level Alarm
Low Level Alarm
Sensor Failure
!
will flash indicating that an alarm condition still exists. This
19