Smappee EV Wall Home Quick Install Manual

Smappee
EV Wall Home
Quick install guide
What's in the box? What's in the box?
Smappee Smappee
EV One Home
EV One Home
Quick install guide Quick Starter guide
EV Wall EV Wall Quick install Quick Starter
mounting plate guide guide
3x 3x
Screw & plug
Small screw Connect Splitter
M32 cable M20 cable Wall mounting Din mounting
gland gland plate plate
3x
CT Hub
CT 50A RJ10 cable RJ10 cable
40cm 150 cm
Bus termination Solid Core
plug 3-Phase CT
2x
Business
Smappee
EV Wall Home
Three phase
Connection diagram
Socket version
L1
L2
L3
N
PE
Power
L1
RCD Box
Lock
L2
L3
L3 L2 L1 N
N
PE
CP
PP
A B B
A+B
Power supply Communication
cable cable
LED Board
Front panel
Fixed cable version
L1
L2
L3
N
PE
Power
L1
RCD Box
L2
L3
L3 L2 L1 N
N
PE
CP
PP
A B B
A+B
Communication
cable
Charging
Power supply
cable
cable
Connect the CT to measure solar
to the correct phase. Adjust the
configuration in the Smappee App
when this is not the L1 phase.
When the solar installation is
3-phased, you need to
purchase and install the
EV Wall solar add-on.
In case of 3-phase delta
(3 x 230 V) or shutter version,
consult the full manual
EN
Safety warning
Carrying out electrical work within the home or
workplace can be dangerous and must be conducted
according to the appropriate national safety
standards and executed by a certified electrician.
For safety purposes, it is also necessary to power off
the installation before proceeding with the physical
installation.
Read the installation manual
carefully before proceeding
as it contains all the safety
and installation instructions.
This manual is available at
smappee.com/downloads
or via the QR code.
Prepare the installation
When positioning the EV Wall, take into account that the power
supply cable and communication cable are entering the housing at
the bottom through cable glands. The central M32 cable gland is
for the power supply, the M20 cable gland for the communication
cable.
Installation and configuration
1. Fix the mounting plate to the wall with the provided plugs and
screws.
2. Attach the EV Wall housing to the EV Wall mounting plate with
the provided small screws.
3. Connect the power supply cable, communication cable and
charging cable (if applicable) to the EV Wall. Connect the cable
to the cover's PCB. Then attach the front panel to the EV Wall
and tighten the M4 nuts to close it.
See diagrams overleaf. In case of 3-phase delta (3 x 230 V) or
shutter version, please consult the full manual online.
4. Connect the EV Wall modules as indicated in the diagram
shown overleaf. The Connect, the Splitter, the CT Hub and
Current Transformers (CTs) are installed inside the distribution
panel. These components communicate with the charging
station via the communication cable.
5. Switch on the power using the circuit breaker.
6. Download the Smappee App and follow the instructions to
configure your Smappee charging station.
7. Once Smappee Connect shows a green pulsing light, validate
the installation by verifying that the real-time bubbles show
correctly measured values in the Smappee App/Dashboard.
8. Use the Smappee app to send an invite to your customer's
email address to share the newly created location with them.
This user account will be used for the Smappee App and
Dashboard and to set smart charging preferences. Lastly, hand
over the Quick Starter Guide.