Smappee EV Wall HOME Quick Install Manual

What's in the box?
EV Wall EV Wall mounting plate
Splitter DIN mounting Connect Wall mounting
plate plate
×3
Bus termination
plug
CT Hub CT 50A
Quick Install
Guide
Smart Charge
RJ10 cable RJ10 cable
EV
Smappee owner
Card
150 cm 40 cm EV Charging station
Quick Starter Guide
×3 ×3
Screw & plug Small screw Quick Starter
QR code
sticker Guide
Optional: 8 m cable with cable holder
EV Wall
HOME
Single phase
Connection diagram
Socket version
L1
L2
L3
N
PE
Power
L1
Box
RCD
Lock
L2
L3
L3 L2 L1 N
N
PE
CP
PP
A B B
A+B
Power supply Cat 5/6
cable communication
cable
LED Board
Front panel
Fixed cable version
L1
L2
L3
N
PE
Power
L1
Box
RCD
L2
L3
L3 L2 L1 N
N
PE
CP
PP
A B B
A+B
Cat 5/6
communication
cable
Charging
Power supply
cable
cable
For more information or
in case of shutter version,
consult the full manual at
smappee.com/downloads
or via the QR code:
Manual
EN

Safety warning

Carrying out electrical work within the home or workplace
can be dangerous and must be conducted according to
the appropriate national safety standards and executed by
a certified electrician.
For safety purposes, it is also necessary to power off
the installation before proceeding with the physical
installation.
For further safety instructions
and more detailed information,
please consult the full manual at
smappee.com/downloads
or via the QR code:
How to install EV Wall HOME
1 Prepare the installation. Foresee a power supply &
communication cable between the EV Wall and the
distribution panel. Note: the power supply cable must
be protected by the appropriate circuit breaker and
RCD where required.
2 Fix the mounting plate to the wall with the provided
plugs and screws.
3 Attach the EV Wall housing to the EV Wall mounting
plate with the provided small screws.
4 Connect the power supply cable, communication
cable and charging cable (if applicable) to the EV Wall.
Connect the cable to the cover's PCB. Then attach the
front panel to the EV Wall and tighten the M4 nuts to
close it.
See diagrams overleaf. In case of shutter version,
please consult the full manual online.
5 Connect the EV Wall modules as indicated in the
diagram shown overleaf. The Connect, the EV Wall
splitter, the CT Hub and Current Transformers (CTs)
are installed inside the distribution panel. These
components communicate with the charging station via
the CAT 5/6 communication cable.
Switch on the power using the circuit breaker.
6
7 Download the Smappee App and follow the instructions
to configure your Smappee charging station.
8 Once Smappee Connect shows a green pulsing light,
validate the installation by verifying that the real-
time bubbles show correctly measured values in the
Smappee App/ Dashboard.
9 Use the Smappee app to send an invite to your
customer's email address to share the newly created
location with them. This user account will be used for
the Smappee App and Dashboard and to set smart
charging preferences. Lastly, hand over the Quick
Starter Guide.