SOMFY Amy 1 A/M Modes io Instructions Manual page 12

EN
3.3.Saving or modifying the favourite position (my)
NOTICE
Refer to the instructions guide for the io drive or receiver to ensure it includes this function.
1] Press the Up or Down button to send the motorised product in the desired
position.
2] Briefly press my to stop the motorised product in the desired position.
3] Press and hold my until the activation of the motorised product to save or to
modify the favourite position (my).
3.4.Auto/Manu (A/M) selector
Amy 1 A/M Modes io allows the user to select the mode for automatism management.
In automatic mode (Auto): the motorised products paired with Amy 1 A/M Modes io also respond to the automatisms,
such as time programming, scene, smart programming, a light sensor, etc...
In manual mode (Manu): the motorised products paired with Amy 1 A/M Modes io only respond to commands performed
manually on Amy 1 A/M Modes io, other paired control points, automatisms or boxes.
Orders sent automatically are inhibited in this mode (such as time programming, scene, smart programming, a light sensor,
etc...). Only so-called safety commands are still taken into account (e.g. a wind sensor).
NOTICE
To use the Auto/Manu (A/M) selector, the front panel buttons and switch must be activated: the product must be
switched on (refer to Switching on Amy 1 A/M Modes io).
To change mode, slide the Auto/Manu (A/M) selector to the desired mode:
▪ Selector on the right (Auto side): automatic mode.
▪ Selector on the left: manual mode.
The feedback LED lights up green when the selector is switched into the other mode.
The selected mode remains active until the Auto/Manu (A/M) selector is switched into the other mode.
3.5.Checking the battery level
When the battery level is low, the feedback LED on the front of Amy 1 A/M Modes io
dims progressively during activation of the motorised product(s). When the battery is
too weak, the control point can no longer transmit radio orders, its operation is
inhibited.
Battery status can be checked on TaHoma application, if Amy 1 A/M Modes io has been added in TaHoma, and an alert may
be sent out if this feature is activated (Follow the instructions in TaHoma application).
3.6.Use with TaHoma
A temperature sensor, not visible, is embedded into Amy 1 A/M Modes io.
This sensor works in combination with TaHoma where it appears as an indoor temperature sensor.
12
1]
2]
3]
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Amy 1 A/M Modes io
5 s
Auto Auto