EN
1] Take the circular back cover and clip the Amy 1 A/M Modes io module onto it,
following the orientation indicated inside the circular back cover. Press firmly
on the front of the module, on the right and left near the my button as close
as possible to the translucent circle without pressing on the edges of the
module (to avoid unwanted radio transmission), until it clicks into place.
2] Amy 1 A/M Modes io can therefore be used as a remote control that can be
put down and moved around.
2.7.Tips and advice on installation
2.7.1.Questions about the product?
Observations
The selected motorised product does not react
at all when a button on Amy 1 A/M Modes io is
pressed (No LED reaction when pressing the
buttons).
The selected motorised product does not react
at all when a button on Amy 1 A/M Modes io is
pressed (No LED reaction in the front when
pressing a button AND in the back when pressing
the On/Off button).
The selected motorised product does not react
at all when a button on Amy 1 A/M Modes io is
pressed but the LED lights up.
The selected motorised product does not react
at all when a button on Amy 1 A/M Modes io is
pressed but the LED lights up and the control
point is paired with this motorised product.
The selected motorised product does not react
as it should.
The motorised product does not react when the
indoor temperature rises (the scenes
programmed in TaHoma in the event of a
change in indoor temperature do not launch).
3.USE AND MAINTENANCE
CAUTION
To prevent damage to the product:
• Avoid impacts!
• Do not drop it!
• Do not spill liquid on the product or immerse it in liquid.
• Do not use abrasive products or solvents to clean the product.
NOTICE
To use the Up, Stop/my or Down buttons, they must be activated: the product must be switched on (refer to
Switching on Amy 1 A/M Modes io).
10
Possible causes
Amy 1 A/M Modes io is switched
off, the front panel buttons (Up,
Stop/my, Down) are deactivated.
The control point battery is low.
The control point is not paired with
this motorised product.
External radio equipment is
interfering with the radio reception.
The selected mode does not match
the type of motorised product.
The temperature feedback to
TaHoma is deactivated on Amy 1
A/M Modes io.
Copyright
Solutions
Switch it on to activate the buttons
(refer to Switching on Amy 1 A/M
Modes io).
Change control point battery as
required (refer to Replacing the
battery).
Refer to Adding/Deleting Amy 1
A/M Modes io.
Turn off any nearby radio
equipment.
Refer to Mode selection.
Check sensor status on TaHoma
application and refer to Use with
TaHoma if necessary.
©
2024 SOMFY ACTIVITES SA. All rights reserved.
Amy 1 A/M Modes io
Need help?
Do you have a question about the Amy 1 A/M Modes io and is the answer not in the manual?