Connecting To The Network - Dell 2161DS-2 Install & User's Manual

Attach one end of the CAT 5 cabling that will run between your PEM and the Remote
2
Console Switch unit to the RJ45 connector slightly separate from the other connectors on
the PEM. Connect the remaining end of the CAT 5 cable to the desired ARI port on the
back of your Remote Console Switch unit.
To one of the eight RJ45 connectors grouped on the back of the PEM, attach the CAT 5
3
cabling that will run between your PEM and each device's SIP .
Connect the other end of the CAT 5 cable to the first of the SIPs.
4
Repeat steps 3-4 for all devices you wish to attach.
5
Figure 2-8. Remote Console Switch Configuration With a PEM
Analog User

Connecting to the Network

To connect the network and power up your Remote Console Switch:
Connect your network cable to the LAN port on the rear of the Remote Console Switch to
1
your network.
Power up all attached systems.
2
Attach your monitor and keyboard and mouse cable connectors to the appropriate ports on
3
the back of your Remote Console Switch unit.
24
Installation
CAT 5e
ARI Port
PEM
SIP or Avocent AVRIQ
Server