Controlling The Status Flag - Dell 2161DS-2 Install & User's Manual

To enable the screen saver mode with no password protection:
If your console does not require a password to gain access to the Security dialog box,
1
proceed to step 2.
or
If your console is password protected, see the previous procedure, then go to step 2.
Select Enable Screen Saver.
2
Type the number of minutes for Inactivity Time (from 1 to 99) to delay activation of the
3
screen saver.
Choose Energy if your monitor is E
4
CAUTION:
Monitor damage can result from the use of Energy mode with monitors not compliant with
Energy Star®.
(Optional) Click Test to activate the screen saver test, which lasts 10 seconds then returns
5
you to the Security dialog box.
Click OK.
6
NOTE:
Activation of the screen saver mode disconnects the user from a device; no device is selected.
The status flag displays the status "Free."
To exit the screen saver mode:
Press any key or move your mouse. The Main dialog box displays and any previous device
connection is restored after the password is validated by the appliance.
To turn off the screen saver:
In the Security dialog box, clear Enable Screen Saver.
1
Click OK.
2
To immediately turn on the screen saver:
Press <Print Screen>, then press <Pause>.

Controlling the Status Flag

The status flag displays on your desktop and shows the name or EID number of the selected
device or the status of the selected port. Use the Flag dialog box to configure the flag to display
by device name or EID number, or to change the flag color, opacity, display time and location on
the desktop.
To access the Flag dialog box:
Press <Print Screen>. The Main dialog box will appear.
1
Click Setup - Flag. The Flag dialog box displays.
2
®
S compliant; otherwise select Screen.
NERGY TAR
33
Basic Operations