Video Optimization; Mouse Acceleration; Connecting A Sip - Dell 2161DS-2 Install & User's Manual

Video Optimization

To ensure optimal video quality, configure the Remote Console Switch with the same settings as
the network switch. For example, if the Remote Console Switch is set to Auto-Negotiate, then
the network switch must be set to Auto-Negotiate in both speed and duplex. For example, if the
Remote Console Switch is set to 100MB - full duplex, then the network switch must be set to
100MB - full duplex.
Once you have made these changes, you may need to refresh/flush the Address Resolution
Protocol (ARP) tables in the network before you establish a new connection with the Remote
Console Switch, especially if the Remote Console Switch has been in use within the hour
proceeding these changes.
To refresh the ARP table, do one of the following:
Wait approximately 10 minutes for the ARP tables to rebuild automatically.
-or-
Clear the ARP table entry in a video session viewer workstation and ping the appliance at its IP
address. This can be done from a DOS window.
Type ARP -d 1.2.3.4
a
(where 1.2.3.4 is the IP address of the Remote Console Switch).
Type PING 1.2.3.4
b
If the PING is successful, the Remote Console Switch is ready for operation.
NOTE:
For further information on refreshing the ARP table refer to the Remote Console Switch Software
User's Guide.

Mouse Acceleration

NOTE:
Dell highly recommends that all Microsoft
Switch use the default Windows
If you are experiencing slow mouse response during a remote video session, deactivate mouse
acceleration in the operating system of the target device and set mouse speed to 50%.

Connecting a SIP

To connect a SIP to each server:
Locate the SIPs for your Remote Console Switch unit.
1
If you are using a PS/2 SIP connection, attach the SIP's color-coded ends to the
2
appropriate keyboard, monitor, and mouse ports on the first server you will be connecting
to this Remote Console Switch. If you are using a USB connection, attach the SIP's plug to
the USB port on the first server you will be connecting to this Remote Console Switch unit
(Figure 2-5).
To the RJ45 connector on the SIP , attach one end of the CAT 5 cabling that will run from
3
your SIP to the Remote Console Switch unit (Figure 2-5).
®
Windows
®
PS/2 or USB mouse driver.
®
systems attached to the Remote Console
19
Installation