To Install The 1U Four Point Switch Mounting Bracket - Dell 2161DS-2 Install & User's Manual

To install the 0U switch mounting bracket (shipped as default):
Line up the holes of the mounting brackets with the screw holes in the switch.
1
Fasten the mounting bracket to the switch using the button head socket cap screws on
2
each side.
Mount the switch assembly to the rack by inserting the three mounting hooks on one side
3
of the bracket into square holes in the vertical rack.
Press down until the blue push button pops out and clicks.
4
Figure 2-1. OU Mounting Bracket Installation

To install the 1U four point switch mounting bracket:

Remove the screws on each side of the 1U four-point switch and set them aside to attach
1
to the front 1U bracket pieces later.
Line up the vent holes in the "long side" of the kit's front brackets with the vent holes in
2
the switch.
Line up the screw holes in the bracket with the screw holes in the switch.
3
With a Phillips screwdriver, fasten the front mounting brackets to the switch using two
4
screws on each side.
Attach four cage nuts or clip nuts to the rack mounting flange of the rack cabinet's front so
5
that the nut is positioned on the inside of the rack.
15
Installation