Page 1
Senior GmbH Assembly Instructions Whirlpool Bath Fx1-9 (03v25) eng Attention The assembly of this pool can be be done with one person!
Page 2
Foreword Dear customer, we are pleased that you have chosen this product. Please observe all instructions before assembly and use and strictly follow the procedure below! Please check the product for completeness first. If there is any damage, please send us a message with a short description and photos of the affected area.
Page 3
Sealing areas under/behind the bathtub Sealing is compulsory - silicone is not enough! The areas behind and under the bathtub must be tiled. Sealant joints - like silicone joints - are not waterproofing, but only maintenance and beauty joints! Only the use of bathtub sealing tapes or e.g.
Preparing the connections ca. 15 cm ca. 30 cm ca. 30 cm Drainage in the floor Waste water via a supplied flexible connection HT 40 Hot water Cold water the distance between the water connections in the floor and the edge of the bathtub must be adapted to the fitting you have chosen.
Page 7
Alignment In order for the pool to stand straight, it is necessary to align the pool exactly with the help of a spirit level. Each foot is individually adjustable, so you can compensate for small irregularities in the floor. Please make sure that all feet are touching the ground and that the weight is evenly distributed on the ground.
Maintenance and cleaning of the pool Clean the pool with a mild liquid detergent and a soft cloth. Caution: Never use ace- tone, cleaning agents containing ammonia or coarse-grained scouring agents! Clear the pool drain regularly of hair and the like to prevent clogging. Use an acrylic care product for the tub and the panel to protect the surface from scratches.
Need help?
Do you have a question about the Fx1 and is the answer not in the manual?
Questions and answers