Page 1
Senior GmbH Assembly Instructions Whirlpool Bath F05/07 (10v24) eng Attention The assembly of this pool can be be done with one person!
Page 2
Foreword Dear customer, we are pleased that you have chosen this product. Please observe all instructions before assembly and use and strictly follow the procedure below! Please check the product for completeness first. If there is any damage, please send us a message with a short description and photos of the affected area.
Page 3
Sealing areas under/behind the bathtub Sealing is compulsory - silicone is not enough! The areas behind and under the bathtub must be tiled. Sealant joints - like silicone joints - are not waterproofing, but only maintenance and beauty joints! Only the use of bathtub sealing tapes or e.g.
Tools for assembly Tools are not included in the package. Spirit level Measuring Phillips / slotted Open-end spanner tape screwdriver Preparing the connections Grey area = possible area for the Hot water drain pipes, in the wall area the Cold water drain can be up to a max.
Page 6
Alignment In order for the pool to stand straight, it is necessary to align the pool exactly with the help of a spirit level. Each foot is individually adjustable, so you can compensate for small irregular- ities in the floor. Please make sure that all feet are touching the ground and that the weight is evenly distributed on the ground.
Defects that can be traced back to calciferous or iron-rich water are excluded from the war- ranty. Please describe the spare part exactly and state the exact pool type (e.g. F05). We are always open to your comments and suggestions.
Page 8
Note Each pool is assembled, connected, tested and repacked at the factory for testing purpos- es. As our products are subjected to several checks during manufacture, small amounts of residual water may be present in parts of the product. Recycling The disposal of the product‘s electronics is governed by the Waste Electrical and Electronic Equipment Act.
Need help?
Do you have a question about the F05 and is the answer not in the manual?
Questions and answers