Page 1
Senior GmbH Assembly Instructions Whirlpool Bath F01/02/03/04/06 (11v23) eng Attention The assembly of this pool can be be done with one person!
Page 2
Foreword Dear customer, we are pleased that you have chosen this product. Please observe all instructions before assembly and use and strictly follow the procedure below! Please check the product for completeness first. If there is any damage, please send us a message with a short description and photos of the affected area.
Page 3
Sealing areas under/behind the bathtub Sealing is compulsory - silicone is not enough! The areas behind and under the bathtub must be tiled. Sealant joints - like silicone joints - are not waterproofing, but only maintenance and beauty joints! Only the use of bathtub sealing tapes or e.g.
Preparing the connections ca. 15 cm ca. 30 cm ca. 30 cm Drainage in the floor Waste water via a supplied flexible connection HT 40 Hot water Cold water the distance between the water connections in the floor and the edge of the bathtub must be adapted to the fitting you have chosen.
Page 6
1850 1700 1100 1100 1700 1155 Alignment In order for the pool to stand straight, it is necessary to align the pool exactly with the help of a spirit level. Each foot is individually adjustable, so you can compensate for small irregularities in the floor.
Page 7
Install drain pipes The drain is in the floor, but the flexible drain hose can also be attached to a drain in the wall, but not higher than 6 cm so that the drain is still allowed. The HT 40 flexible connection used for this is included in the delivery.
Warranty and service You receive a 2-year warranty for our products. A warranty period of 6 months applies to wearing parts such as seals, hand showers and shower hoses. The costs for replacement are not covered. Spare parts can be ordered from our customer service. E-mail: kundenservice@seniorbad.de Online shop: www.seniorbad.de...
Need help?
Do you have a question about the F02 and is the answer not in the manual?
Questions and answers