Related Manuals for Senior Bad AcquaVapore W83
Summary of Contents for Senior Bad AcquaVapore W83
- Page 1 Senior GmbH Assembly Instructions Whirlpool Bath (10v19) eng Attention: The assembly of this pool should be done by two people!
- Page 2 Foreword Dear customer, we are pleased that you have chosen this product. Please observe all instructions before assembly and use and strictly follow the procedure below! Please check the product for completeness first. If there is any damage, please send us a message with a short description and photos of the affected area.
- Page 3 Sealing areas under/behind the bathtub Sealing is compulsory - silicone is not enough! The areas behind and under the bathtub must be tiled. Sealant joints - like silicone joints - are not waterproofing, but only maintenance and beauty joints! Only the use of bathtub sealing tapes or e.g.
-
Page 4: Technical Data
Technical data Outside dimensions of the pool 185 cm Length 90 cm Wide 60 cm Hight Hot and cold water connection ½ inch max. 4 Bar Waist water HT 40mm Power connection 220-240 V 50 Hz max. 4 A Massage pump water 600 W Max. - Page 5 Designations Display/control panel (R variant) Massage settings Display / Kontrollpanel Unterwassermassage Cold water Underwater massage Kaltwasser Farbspot Warmwasser Ab ussö ner Hot water Colour spot Umschalter Wasseransauger Change-over switch Drain opener Whirlpool AN/AUS Kopfstützen Whirlpool ON / OFF Water aspirator Wassereinlauf Unterwassermassage Handbrause...
-
Page 6: Installing The Drain
Alignment In order for the pool to stand straight, it is necessary to align the pool exactly with the help of a spirit level. Each foot is individually ad- justable, so you can compensate for small irregularities in the floor. Please make sure that all feet are touching the ground and that the weight is evenly distributed on the ground. - Page 7 Commissioning/leak test For the leak test, please now connect the water and waste water with the hose connections. It is important that the tub continues to stand away from the wall so that you can still operate behind it. Before you put the pipe under water pressure, please note that it has only been pre-assembled by the factory to make it easier for you to set it up.
-
Page 8: Warranty And Service
Maintenance and cleaning of the pool Clean the pool with a mild liquid detergent and a soft cloth. Caution: Never use ace- tone, cleaning agents containing ammonia or coarse-grained scouring agents! Clear the pool drain regularly of hair and the like to prevent clogging. Use an acrylic care product for the tub and the panel to protect the surface from scratches.
Need help?
Do you have a question about the AcquaVapore W83 and is the answer not in the manual?
Questions and answers