Related Manuals for Senior Bad S17D
Summary of Contents for Senior Bad S17D
- Page 1 Senior GmbH Assembly Instructions Whirlpool Bath S17D (08v22) eng Attention: The assembly of this tub should be done by two people!
- Page 2 Foreword Dear customer, we are pleased that you have chosen this product. Please observe all instructions before assembly and use and strictly follow the procedure below! Please check the product for completeness first. If there is any damage, please send us a message with a short description and photos of the affected area.
- Page 3 Sealing areas under/behind the bathtub Sealing is compulsory - silicone is not enough! The areas behind and under the bathtub must be tiled. Sealant joints - like silicone joints - are not waterproofing, but only maintenance and beauty joints! Only the use of bathtub sealing tapes or e.g.
-
Page 4: Technical Data
Technical data Outside dimensions of the pool 150 cm Length 75 cm Width 54 cm High Hot and cold water connection ½ Inch max. 4 Bar Waste water HT 40mm Power connection 220-240 V 50 Hz max. 4 A Massage pump water 900 W Max. -
Page 5: Product Components
Product components Sanitary acrylic bathtub with door Wall rail Shower door Wall plug Screws Wall rail Connecting Washers and Door seal screw to the Cover caps wall rail... - Page 6 Dimensioning Designations Hot/cold water Switch Bath filler/ Hand shower Hand shower Setting massage jets Massage jets on/off Bath filler Water suction Massage jets Drain opener Drain Warm-/Kaltwasser Umschalter Wanneneinlauf - Handbrause ...
-
Page 7: Preparing The Connections
Preparing the connections S17D right 15-100 cm 20 cm 20 cm 21 cm 33cm Hot water 1/2 Inch Cold water 1/2 Inch - Connections can also be on the opposite side (possible with hose extension) Grey area = possible area for the drain pipes, in the wall area the drain can be up to a max. - Page 8 S17D left 15-100 cm 20 cm 20 cm 21 cm 33cm Hot water 1/2 Inch Cold water 1/2 Inch - Connections can also be on the opposite side (possible with hose extension) Grey area = possible area for the drain pipes, in the wall area the drain can be up to a max.
-
Page 9: Installing The Drain
Alignment In order for the pool to stand straight, it is necessary to align the pool precisely with the help of a spirit level. Each foot is individually adjustable, so you can compensate for small irregularities in the floor. Please make sure that all feet are touching the ground and that the weight is evenly distributed on the ground. - Page 10 Connecting the cold and hot water After the drain pipes have been installed, the water is now connected. The cold water con- nection is on the right and the hot water connection is on the left. Wand Wall Hot water Cold water Kaltwasser Warmwasser...
-
Page 11: Door Assembly
Door assembly Now slide the door C into the wall rail. Now fix the door to the holes provided with the screws C1 and washers C2. Finally, put on the cover caps. Door seal Do not forget to attach the door seal C3 to the bottom edge of the door. Cut the seal on the hinge side with a cutter knife as shown in the illustration. -
Page 12: Warranty And Service
Fax: Defects that can be traced back to calciferous or iron-rich water are excluded from the warranty. Please describe the spare part exactly and state the exact pool type (e.g. S17D). We are always open to your comments and suggestions.
Need help?
Do you have a question about the S17D and is the answer not in the manual?
Questions and answers