Maintenance
Your dehumidifieris designedto serve you year-
round. It needs practicallyno attention. However,
you shouldcheck your dehumidifierand inspectthe
coils annually.
You may want Sears Parts & RepairCenter to
perform this annual checkup. (Cost of the inspection
is the owner's responsibility.)
OR
If you are familiar with electricalappliances and their
functions, listed below are instructionswhich would
allow you to perform the inspectionand
maintenancefor yourself.
Cleaning
the front
case,
bucket
and cabinet
Clean the front case and the cabinetwith a soft
cloth, warm water, and a mild detergent.
Clean the grille with a vacuumattachmentor brush.
Do not use bleach or abrasives.
Cleaning
the air filter
1. Removewater bucketfrom the cabinet.
Pull out the air filter as shown above.
2. Wash air filter with warm water and a mild
detergent. Rinse and dry it.
Replaceit in the unit.
ElectricalShock Hazard
• Disconnectpower supply cord from receptacle
beforeperformingany maintenance.
• Be careful when cleaningthe coils.
Fins are sharp.
Failureto follow the above precautionscould result
in electricalshock or personalinjury.
Cleaning
the coil
1.
RemoveFront Grille from the cabinet as shown.
2. Use a small brushto gently clean the coils as
shown.
If necessaryuse warm water and a mild
detergent. Rinse and dry thoroughly.
_
AUTION
: Do not spray
the coil
with a water
hose.
Be careful!
Sharp
edges!
14
Dehumidifier
Need help?
Do you have a question about the 54351 - 35 Pint Dehumidifier and is the answer not in the manual?
Questions and answers
i want to collect water only in the bucket and not go to hole outlet is there a special way to change it
To set the Kenmore 54351 - 35 Pint Dehumidifier to collect water only in the bucket instead of the hose outlet, follow these steps:
1. Remove the drain hose if it is attached.
2. Ensure the drain hole cover is in place to block the hose outlet.
3. Make sure the water bucket is properly installed in its correct position.
The dehumidifier will then collect water in the bucket, and you will need to empty it manually when full.
This answer is automatically generated