Table of Contents
Advertisement
Available languages
Available languages
Operating Instructions
I_i;_,i_:i_!_i_i_!_i!ii
¸_i_i!_ii!_!!i!!_i!_iiii!ii!_!_!_!
'i' i!ili!i !
CONTROL PANEL
Your dehumidifierhas a control panel containingan Auto shut-off indicator,a Fan Speed and Humidity Control.
Auto shut off--- This light glows when the bucket fills or is missing.
Fanspeed --- This switch controlsthe speed of the airflow.
HumidityControl---This knob controlsthe moisturein the room.
TO OPERATE
THE DEHUMIDIFIER:
1.Turn the Humidity Controlto Off. Plug the power supply cord into an electricaloutlet.
2. The Humidity Control can be set anywhere between Off and Maxfor normal operation.
If you need moredehumidification,turn the HumidityControl toward Max. If you need less dehumidification,
turn the Humidity Controltoward Off.
3. Turn the Humidity Controlto Off to stop the unit manually.
4. If you want to control the speed of air flow, turn the Fan Speed toward Low or High.
Water bucket must be properly installed.
• The dehumidifier will not run if the bucket is not properly installed.
• The dehumidifier shuts off when the desired humidity setting is reached.
Owner's Manual
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 54351 - 35 Pint Dehumidifier and is the answer not in the manual?
Questions and answers
i want to collect water only in the bucket and not go to hole outlet is there a special way to change it
To set the Kenmore 54351 - 35 Pint Dehumidifier to collect water only in the bucket instead of the hose outlet, follow these steps:
1. Remove the drain hose if it is attached.
2. Ensure the drain hole cover is in place to block the hose outlet.
3. Make sure the water bucket is properly installed in its correct position.
The dehumidifier will then collect water in the bucket, and you will need to empty it manually when full.
This answer is automatically generated